Pcbway Rfq

Rules

• PCBWay ambiguity-reduction guidance outranks convenience; if they ask for assembly drawings, special instructions, or marked images, treat them as required deliverables
• call out critical no-change geometry explicitly
• separate fit-prototype requirements from final wet-service requirements
• avoid silent assumptions about sourcing or assembly responsibility
• request PLA first when minimizing prototype cost unless the task says otherwise
• for any multi-part FDM prototype export, keep the parts in one compact bundle, minimize the XY footprint, put broad flat exterior faces down, keep open cavities and grooves up, and keep hose-plug bores vertical with the hose ends up when practical
• for interlocking printed support parts, describe hidden matching joint letters and light alignment detents as intentional assembly aids so the vendor does not remove them as cosmetic artifacts
• if supplemental SVGs are included, make sure they match the current SCAD geometry, carry reference-only metadata, and never substitute for a formal release drawing
• for mechanical release packages, require clear units, material, finish, release status, and critical dimensions in the 2D drawing or PDF
• require explicit approval before any manufacturability-driven geometry change